FEATURES OF YOUR GARMENT STEAMER
OPERATING INSTRUCTIONS cont.
1.The steam diffuser/handgrip at the end of the steamer hose is located just behind the garment brush. By grasping the steam diffuser/handgrip you can aim the direction of the steam released from the nozzle.
Caution: The steam hose becomes hot during use. Never hold, pull or move unit by the hose while in use.
2.The garment brush with its small openings is located at the end of the steamer hose. Always place the nozzle end of the hose on the garment hanger when not in use. Keep the nozzle pointed upwards and steam will rise from the openings. Try not to point the nozzle downwards, water may condense in the hose during idle periods and drip from the nozzle.
3.The garment rod has a convenient hook shaped end for resting the nozzle end of the hose. It can be extended and retracted by adjusting the telescopic rod in its sleeve.
4.The On/Off switch button can be foot activated to turn the power “ON” or “OFF”.
5.The ready light (green) comes on when the unit is turned “ON”.
6.The water tank is removable for easy filling and is see through for easy monitoring of the water level. The screw cap is fitted with a one way valve to ensure drip free replacement of the water tank when refilling.
7.The Garment Steamer base houses the reservoir, water tank, hose attachment and adjustable garment rod.
Step 3: Using Garment Steamer cont.
4.Once steam is being released from the steam diffuser with the garment brush attached, hold the handgrip with the nozzle facing upward and begin steaming from the bottom of the garment allowing the escaping steam to rise inside and out side removing the wrinkles. (See fig. 10)
5.After a few seconds, remove the steam diffuser from the garment and smooth the garment with your free hand and check to see if more steam is required.
Note: Do NOT leave the steam diffuser in one area for a long period of time because the garment will get wet.
Fig. 10
Important: For heavier fabrics, you may need to use repeated applications. Avoid heating a single area with steam for a prolonged period. Check the garment to see that the process is succeeding.
Step 4: Maintenance & Storage
1.Turn the unit “Off”. The power on light (green) will go out. Disconnect the plug from the electrical outlet.
2.Wait for garment steamer to cool down completely for at least 30 minutes before draining the water tank.
3.After the unit has cooled down, remove the water tank and empty the water remaining in the water tank in a sink. Rinse the water tank and set aside to dry.
4.Disconnect the steamer hose from the unit and set aside.
5.Disconnect the garment rod entirely from the unit.
6.Lift the unit over a sink and empty what water has remained in the water reservoir. Wash the interior of the reservoir by flushing with some tap water. This will dislodge any sediment that has accumulated. Drain this water from the reservoir and dry.
7.Reattach the garment rod and steamer hose or store separately.
8.Once the unit has dried, you may store in a cool, dry place.
Important: If you wish to leave your steamer ready for use on a daily basis, simply leave the water bottle filled and in place. While you do not have to empty the water bottle each day, you should periodically empty the old water out of the steamer and remove any sediment that has accumulated. We recommend that you empty and clean it once a month depending on amount of use and water mineral content in your area.
Safety Thermostat
Should your unit run out of water, the safety thermostat will trip in order to prevent damage to the unit. To reset, unplug unit, refill water tank,
3
8