Ironing With Steam

•Make sure that the Steam Station is unplugged from the power source.

•Set the variable steam control (2) TO “0”. (Fig. 3)

•Fill the water tank (8A) with tap water, following the instructions for filling the water tank.

•Make sure that the iron is resting on top of the rubber mat (10).

IMPORTANT: Do not place the rubber mat (10) on a table or any other surface which may be damaged by heat.

Fig. 3

Fig. 4

•Plug the power cord (11) into the 120 volt AC electrical outlet.

•Set the temperature control dial (1) to the steam area. (Fig. 4) ••For Moderate Steam

•••For Maximum Steam

•Activate the water pump by pulling on the trigger (3). (Fig. 5)

Note: You can push the trigger lock (3A) backwards to keep the trigger (3) in a pulled position permanently.

•Make sure that the iron has reached the selected temperature before using steam.

Fig. 5

IMPORTANT: Do not open the steam control (2) or push the burst-of-steam knob (6) until the temperature pilot light (7) goes off indicating that the selected temperature has been reached. If you activate any of the above before the correct temperature is reached, the iron will drip water.