Operation Instructions

7.Replace Water Reservoir Cap and push filled Water Reservoir back into main unit.

*DO NOT ATTEMPT TO PULL WATER RESERVOIR OUT COMPLETELY.

OPERATION INSTRUCTIONS

1.Turn the ON/OFF Switch to the"on"position.

2.Identify the type of fabric you will press and then select the temperature setting that matches the fabric to be pressed. It is best to start with the most delicate fabrics first, as higher heat will cause damage to Nylon and Silks.

3.Lay fabric flat on Ironing Board.

4.Digital Fabric Steam Press is ready for use when Pressing Indicator Light deactivates. If pressing wool, you may choose to spray with a burst of steam. This function is available once Steam Burst Ready Indicator Light illuminates. NOTE: Do not activate burst of steam with unit completely closed, as this may damage unit. Best results are obtained if Pressing Plate is held open approxi- mately 75 mm above Ironing Board before pressing Steam Button. For safety reasons, do not hold Pressing Plate open more than 75 mm when using steam burst function.

5.To press, lower Pressing Plate gently onto fabric and Ironing Board. Hold there for 6-8 seconds, then lift up Pressing Plate. Repeat until you have achieved desired crease and smoothness.

6.Once Pressing tasks are complete, immediately set On/Off Switch to "off"position.