Panasonic NA-F90H2 operating instructions Child Lock Program, Cancelling end buzzer after washing

Child Lock Program

This is an emergency alarming mode with a continuous buzzer sounds when child open the lid during operation to prevent a child from drowning (condition where there is a water inside the tub) by falling into the tub which contains water.

Close the lid to stop the buzzer. If the lid is kept open for more than 10 seconds, the machine will force drain the water inside the tub assuming that the child had fallen into the tub but make sure that the drain hose is laid down.

• This is different from the function that lock button operation and the lid.

7IN THE CASE OF FORCE DRAINING.

There will be an abnormal alarm (flickering of lamps and buzzer). Please check inside the tub.

7RESET METHOD OF ABNORMAL ALARM.

Button operation cannot be used.

At first, unplug the power cord from the outlet and re-plug it again after 5 seconds. Please repeat the operation from the beginning because the process had been cancelled.

7 Please do not leave water inside the tub as [Child Lock] mode does not function in the following case:

•In the case of power supply off.

•In the case when forget to lay down the drain hose.

•Please close the lid immediately after press the [Start/Pause] button because when the lid is open, there will be an abnormal alarm and force drain during water feeding.

1. Press the [Power On] button.

2. Press the [Program] button for at least 5 seconds.

7SETTING METHOD

1.Press the [Power On] button.

2.Press the [Program] button for at least 5 seconds.

The buzzer sounds (two times for setting) and the [Child Lock] indication turns on.

Remark: will be indicated on time display only 2 seconds and then it will be turn off.

7CANCELLING METHOD

Repeat the operation 1 and 2.

The buzzer sounds (4 times for cancelling) and the [Child Lock] indication turns off.

[NOTE]

When you press [Program] button, it switches over, from “Normal” to “Speedy”, for example. To set it back to “Normal”, turn off the power and turn it on again.

Cancelling end buzzer after washing

2. Press

1. While pressing

1.Press [Start/Pause] button and [Power On] button at the same time, release [Power On] button and hold [Start/Pause] button at least for 3 seconds. Two times beep sound indicates the end buzzer of washing has been cancelled.

•Repeat step 1 to activate the end buzzer. Four times beep sound indicates the end buzzer has been activated.

•When the power cord is unplugged or a power outage occurs, the last setting of the end buzzer will be remained.

16

NA-F90H2_EN_AR-PE-V2.indd 16

11/23/11 3:41:36 PM