Installation Instructions
WASHER CONNECTIONS FOR STATIONARY MODELS WSLS1100 AND WSLM1100
WARNING: Make sure the washer is unplugged.
1FLUSH WATER LINES
Run some water from the hot and cold faucets to flush the water lines and remove particles that might clog up the water valve screens.
2CONNECT TO WATER LINES
Connect the inlet hose ends to the HOT and COLD water faucets tightly by hand, then tighten another 2⁄3 turn with pliers. Turn the water on and check for leaks.
3CAREFULLY MOVE THE WASHER TO ITS FINAL LOCATION
4CONNECT DRAIN HOSE
Form a U shape on the end of the drain hose with the hose pointed toward the drain. Place the hose in a laundry tub or stand pipe and secure it with a cable tie (not included).
NOTE: If the drain hose is placed in a stand pipe without forming a U shape, a siphoning action could occur. There must be an air gap around the drain hose. A snug hose fit can also cause a siphoning action.
Cable Tie
Laundry Tub
Cable Tie
Cable Tie
Stand Pipe
5PLUG THE POWER CORD INTO A GROUNDED OUTLET
Insure proper ground exists before use
11