Panasonic WSLS1100, WSLP1100 Connect to Water Line, Connect to Valve Inlet, Tighten Connector

Page 13

Installation Instructions

WASHER CONNECTIONS FOR PORTABLE MODEL WSLP1100—ONE-FAUCET CONNECTIONS

Use the hose connector provided with the washer for a one-faucet connection.

TO CONNECT THE WASHER:

1REMOVE THE UNI-COUPLE®HOSE FROM INSIDE THE WASHER BASKET

Drain Connection

Faucet Connector

COLD Water

Supply Connector

Water Filter

Uni-Coupler Hose

2CONNECT TO WATER LINE

Attach the hose connector to the faucet adapter by pulling down on the locking collar while lifting up on the connector until it snaps into place. Make sure the water filter provided is in place.

Locking Collar

3CONNECT TO VALVE INLET

Attach the COLD water supply connector to the COLD water valve inlet (color BLUE). Make sure the washer is inside the connector before tightening.

4TIGHTEN CONNECTOR

Tighten the connector, ensuring the threads are aligned properly for tightest fit. Inspect for kinks or binding of the hose.

NOTE: Do not remove the plastic cap from the HOT water inlet for uni-coupler connections as leakage may occur.

Plastic Cap

5CONNECT DRAIN HOSE

Attach the drain hose to the rear of the washer. Install the clamp on the drain hose and tighten to prevent leakage of water.

Hose Connector

13

Page 12 Page 14
Image 13
Page 12 Page 14
Contents Washers Your Laundry Area When not in USE To clean Special washer featuresTo Use the Detergent Dispenser To Use the Fabric Softener DispenserTo Use Automatic One-Touch Washing About the control and indicator settingsTo Choose Your Own Cycle Selections START/PAUSE Care and Cleaning of the Washer Loading and using the washerSorting Wash Loads Proper Use of DetergentMachine wash Cycle Fabric Care LabelsWasher Location Rack InstallationPlumbing Parts SuppliedGrounding Instructions Electrical RequirementsPush the Leveling Locks Back Flush Water Lines Plug the Power Cord Into a Grounded OutletConnect to Water Lines Connect Drain HoseRUN the Washer Through a Complete Cycle Installation ChecklistRead the Rest of this Connect to Water Line Tighten ConnectorConnect to Valve Inlet Make Sure the Temperature Selector is SET AT COLD/COLD Drain Water Disconnect from Water LineSecure the drain hose to the sink or stand pipe Status Indicators Before you call for service…Too many suds Water temperatureWater leaks Is incorrectColored spots Washer won’t operateGrayed or yellowed ClothesPerformance cont’d Peel off cleanlyOr excessive wear WrinklingWe’ll Cover Any Appliance. Anywhere. Anytime Consumer Product Ownership Registration Five Years One YearParts and Accessories Schedule ServiceConsumer Support GE Appliances Website Real Life Design Studio
Top Page Image Contents