AEG L64850L, LAVAMAT 64850L Water drainage, End of the drain hose can be positioned in three ways

Page 32

Installation 31

be sure to tighten the ring nut again to prevent leaks.

The inlet hose must not be lengthened. If it is too short and you do not wish to move the tap, you will have to purchase a new, longer hose specially designed for this type of use. Installation should comply with local water authority and building regulations require- ments. A minimum water pressure of 0.05 MPa is required for safe operation of the appli- ance.

Before connecting up the machine to new pipework or to pipework that has not been used for some time, run off a reasonable amount of water to flush out any debris that may have collected in the pipes.

Water drainage

The end of the drain hose can be positioned in three ways:

1.Hooked over the edge of a sink using the plastic hose guide supplied with the machine.

In this case, make sure the end cannot come unhooked when the machine is emptying.

This could be done by tying it to the tap with a piece of string or attaching it to the wall.

2. In a sink drain pipe branch. This branch must be above the trap so that the bend is at least 60 cm above the ground.

3. Directly into a drain pipe at a height of not less than 60 cm and not more than 90 cm.

The end of the drain hose must always be ventilated, i.e. the inside diameter of the drain pipe must be larger than the outside diameter of the drain hose.

The drain hose must not be kinked.

The drain hose may be extended to a maximum of 4 metres. An additional drain hose and joining piece is available from your local Service Centre.

Image 32
Contents User’s Manual Lavamat 64850L Contents Safety information General safetyInstallation Safety informationChild Safety UseProduct description Detergent dispenser drawer Control panel Drain pump Adjustable feetControl panel Display Duration of selected programmeIndicator pilot lights Acoustic signalsChild safety lock PersonalizationDaily use Load the laundryMeasure out the detergent and the fabric softener Daily useSelect the desired Temperature Button Select the Spin speed or the Rinse Hold option ButtonProgramme option buttons Relevant light will light upSelect the Delay Start Button Select the Stain option ButtonSelect the Sensitive option Button Select the Time Saving option ButtonCancelling a programme Select an additional rinse Extra RinseAltering an option or a running programme Interrupting a programmeHelpful hints and tips Opening the door after the programme has startedAt the end of the programme Sorting out the laundryHelpful hints and tips Removing stainsDetergents and additives Washing programmes Quantity of detergent to be usedDegrees of water hardness Washing programmesMain wash Rinses Long spin at 1200 rpm Max. load 3,5 kg Rinse option will be activated automaticallyMain wash Rinses Short spin at 1200 rpm Max. load 3,5 kg Reduced load 2 kgWool / Handwash Max. load 2 kg Rinses Short spin at 1200 rpmMax. load 7 kg Relevant buttonCare and cleaning Maintenance washCare and cleaning DescalingExternal cleaning Washing drumDoor seal Drain pumpCleaning the water inlet filters Emergency emptying out Turn on the water tapFrost precautions What to do if…Clean the drain filter What to do if…Reduce the detergent quantity or use anoth- er one Replace it with a new oneConsumption values Consumption valuesWhite Cottons Programme 60Technical data InstallationUnpacking Cottons Synthetics DelicatesInstallation Unscrew the three boltsInstallation Slide out the relevant plastic spacers Positioning and levelling Water inletWater drainage End of the drain hose can be positioned in three waysElectrical connection Environment concernsPackaging materials Ecological hintsPage Warranty Showroom