AEG LN 79680A3, LN 79689A3 user manual Water-stop device, Water drainage

Page 34

34Installation

3.Set the hose correctly by loosening the ring nut. After positioning the inlet hose, be sure to tighten the ring nut again to prevent leaks.

4.Connect the hose to a tap with a 3/4” thread. Always use the hose supplied with the appliance.

The inlet hose must not be lengthened. If it is too short and you do not wish to move the tap, you will have to purchase a new, longer hose specially designed for this type of use. Note ! Check if the water connections are tight.

Installation should comply with local water authority and building regulations require- ments. Check the minimum water pressure required for safe operation of the appliance in the chapter "Technical Data".

Water-stop device

The inlet hose is provided with a water stop de- vice, which protects against damage caused by water leaks in the hose which could develop due to natural ageing of the hose. This fault is shown by a red sector in the window «A». Should this oc- cur, turn the water tap off and refer to your Serv- ice Centre to replace the hose.

A

Water drainage

The end of the drain hose can be positioned in three ways:

1.Hooked over the edge of a sink using the plastic hose guide supplied with the machine.

In this case, make sure the end cannot come unhooked when the machine is emptying.

Image 34

Contents Lavamat LN 79680A3 Lavamat LN 79689A3 Contents Safety information Water drainage Packaging materials Safety InformationGeneral safety Ecological hintsChild Safety InstallationUse Product Description Control Panel Detergent dispenser drawerSymbols DisplayFirst USE Acoustic signalsChild safety lock PersonalizationMeasure out the detergent and the fabric softener Daily USELoad the laundry Daily useSelect the desired Temperature Button Turn the programme dial 1 to set the required programmeProgramme option buttons Prewash optionExtra Rinse option additional rinse Stain optionSensitive option Select the Time Saving option buttonAltering an option or a running programme Select the Delay Start buttonCancelling a programme Interrupting a programmeOpening the door after the programme has started At the end of the programmeWashing Programmes 40- 60 MIXGarments, non-shrink shirts, blouses Main wash Rinses Short spin at 1200 rpmMax. load 4 kg Reduced load 2 kg Max. load 1.5 kgDrain and long spin at maximum spin speed Max. load 8 kg Draining of water Max. load 8 kgSelected Main wash Rinses Short spin at 800 rpm Max. load 2 kg20 MIN. 3KG Before loading the laundry Helpful Hints and TipsSorting out the laundry Removing stainsDetergents and additives Quantity of detergent to be usedCare and Cleaning Door seal Washing drumDrain pump Clean the filter under a tap, to remove any traces of fluff Cleaning the water inlet filters Frost precautions Emergency emptying outWhat to do IF… Washing machine does not startSpin Machine does not fillThere is water on the floor Door will not open Unsatisfactory washing resultsMachine vibrates or is noisy Force Centre Technical DataNo water is visible in the drum Plate, on the inner edge of the appliance doorConsumption Values InstallationUnpacking Page Page Rubber feet kit Positioning and levellingWater inlet Water-stop device Water drainageElectrical Connection Packaging materials Environment ConcernsEcological hints Page Page Page 132943471-A-282011