AEG L 60270 user manual AT the END of the Programme, Cancel the Delay Start, Open the Door

Page 16

16 www.aeg.com

When the countdown is completed, the programme starts automatically.

Before you press button 4 to start the appliance, you can cancel or change the set of the delay start.

CANCEL THE DELAY START

1.Press button 4 . The related indica- tor flashes.

2.Press button 5 again and again until the display shows 0’.

3.Press button 4 . The programme starts.

OPEN THE DOOR

While a programme or the delay start op- erates, the appliance door is locked.

To open the appliance door:

1.Press button 4 . The door lock sym- bol in the display goes off.

2.Open the appliance door.

3.Close the appliance door and press button 4 . The programme or the delay start continues.

If the temperature and level of the water in the drum are too high, the door lock symbol stays on and you cannot open the door. To open the door do the steps that follow:

1.Deactivate the appliance.

2.Wait for some minutes.

3.Make sure that no water is in the drum.

If you deactivate the appliance, it is necessary to set the programme again.

AT THE END OF THE PROGRAMME

The appliance stops automatically.

The acoustic signals operate.

In the display comes on.

The indicator of the Start/Pause button 4 goes off.

The door lock symbol goes off.

Press button 1 to deactivate the ap- pliance. After five minutes from the end of the programme, the energy saving function automatically deactivates the appliance.

When you activate the appliance again, the display show the end of the last set programme. Turn the programme knob to set a new cy- cle.

Remove the laundry from the appli- ance. Make sure that the drum is emp- ty.

Keep the door ajar, to prevent mildew and odours.

Close the water tap.

The washing programme is completed, but there is water in the drum:

The drum turns regularly to prevent the creases in the laundry.

The door stays locked.

You must drain the water to open the door.

To drain the water:

1.If necessary, decrease the spin speed.

2.Press the Start/Pause button 4 . The appliance drain the water and spin.

3.When the programme is completed and the door lock symbol goes off, you can open the door

4.Deactivate the appliance.

The appliance drain and spin au- tomatically after approximately 18 hours.

Image 16
Contents 60270 FL Environment Concerns ContentsVisit OUR Website for Customer Care and Service Accessories and ConsumablesFor Perfect Results Safety Information General SafetyCare and Cleaning InstallationTechnical Information Discard the ApplianceAccessories Product DescriptionControl Panel On OFF ButtonProgramme Knob DisplayDelay Start Button START/PAUSE ButtonTime Save Button Extra Rinse ButtonTemperature Button Acoustic Signals FunctionChild Lock Function Permanent Extra Rinse FunctionProgrammes Time SaveSpar TID1 Consumption Values Using the Appliance Before First USELoading the Laundry Filling the Detergent and AdditivesCheck the position of the flap Setting and Starting a Programme Cancel a ProgrammeSET the Delay Start Interrupt a ProgrammeAT the END of the Programme Cancel the Delay StartOpen the Door Hints and Tips Laundry LoadStubborn Stains Detergents and AdditivesLevel Type Water hardness Mmol/l Clarke Medium Care and Cleaning Detergent Dispenser Drain PumpEnglish Inlet Hose Filter Valve FilterFrost Precautions Emergency DrainTroubleshooting Delay start is set Problem Possible cause Possible solution Special Accessories for Installation InstallationUnpacking Page English Positioning and Levelling Inlet HoseWater-stop device Water DrainagePage English Page English 132928910-A-02-2012