AEG L 60270 user manual Problem Possible cause Possible solution

Page 26

26 www.aeg.com

Problem

Possible cause

Possible solution

 

 

 

You did not remove the stubborn stains before you wash the laundry.

Use special products to remove the stubborn stains.

Incorrect temperature

Make sure that you set the cor-

was set.

rect temperature.

Too much laundry load.

Decrease the laundry load.

 

 

After the check, activate the appliance. The programme continues from the point of interruption.

If the problem occurs again, contact the service centre.

If the display shows other alarm codes, contact the service centre.

Image 26
Contents 60270 FL Visit OUR Website for ContentsEnvironment Concerns For Perfect Results Accessories and ConsumablesCustomer Care and Service Care and Cleaning Safety InformationGeneral Safety InstallationTechnical Information Discard the ApplianceAccessories Product DescriptionProgramme Knob Control PanelOn OFF Button DisplayTime Save Button Delay Start ButtonSTART/PAUSE Button Extra Rinse ButtonChild Lock Function Temperature ButtonAcoustic Signals Function Permanent Extra Rinse FunctionProgrammes Time SaveSpar TID1 Consumption Values Loading the Laundry Using the ApplianceBefore First USE Filling the Detergent and AdditivesCheck the position of the flap SET the Delay Start Setting and Starting a ProgrammeCancel a Programme Interrupt a ProgrammeOpen the Door Cancel the Delay StartAT the END of the Programme Stubborn Stains Hints and TipsLaundry Load Detergents and AdditivesLevel Type Water hardness Mmol/l Clarke Medium Care and Cleaning Detergent Dispenser Drain PumpEnglish Inlet Hose Filter Valve FilterFrost Precautions Emergency DrainTroubleshooting Delay start is set Problem Possible cause Possible solution Unpacking InstallationSpecial Accessories for Installation Page English Positioning and Levelling Inlet HoseWater-stop device Water DrainagePage English Page English 132928910-A-02-2012