22 www.aeg.com
Problem | Possible cause | Possible solution |
The appliance fills | The end of the drain | Make sure that the drain hose is |
with water and | hose is too low. | in the correct position. |
drain immediately. |
|
|
The washing re- | The detergent you used | Increase the detergent quantity |
sults are not satis- | was not sufficient or cor- | or use a different one. |
factory. | rect. |
|
|
|
|
You did not remove the stubborn stains before you wash the laundry.
Use special products to remove the stubborn stains.
Incorrect temperature | Make sure that you set the cor- |
was set. | rect temperature. |
Too much laundry load. | Decrease the laundry load. |
|
|
After the check, activate the appliance. The programme continues from the point of interruption.
If the problem occurs again, contact the service centre.
If the display shows other alarm codes, contact the service centre.
TECHNICAL INFORMATION
Dimensions | Width / Height / Depth | 400 / 850 / 600 mm |
Electrical connection: | Voltage | 230 V |
| Overall power | 2200 W |
| Fuse | 10 A |
| Frequency | 50 Hz |
Water supply pressure | Minimum | 0,5 bar (0,05 MPa) |
| Maximum | 8 bar (0,8 MPa) |
Water supply 1) |
| Cold water |
Maximum load | Cotton | 6 kg |
Spin speed | Maximum | 1200 rpm (L60260TL) |
|
| 1000 rpm (L60060TL) |
|
|
|
1)Connect the water inlet hose to a water tap with a 3/4'' thread.