ENGLISH 19
4.Remove the inlet hose behind the appliance.
5.Clean the filter in the valve with a stiff brush or a towel.
90˚ |
6.Install again the inlet hose. Make sure that the couplings are tight to pre- vent leakages.
7.Open the water tap.
EMERGENCY DRAIN
Because of a malfunction, the appliance cannot drain the water.
If this occurs, do steps (1) through (3) of 'To clean the drain filter'.
If necessary, clean the filter.
Put the drainage duct back and close the drain filter flap.
5.Disconnect the appliance.
WARNING!
Make sure that the temperature is more than 0 °C before you use the appliance again.
The manufacturer is not responsi- ble for damages caused by low temperatures.
FROST PRECAUTIONS
If the appliance is installed in an area where the temperature can be less than 0 °C, remove the remaining water from the inlet hose and the drain pump.
1.Close the water tap and disconnect the inlet hose.
2.Put the end of the inlet hose in a con- tainer and let the water flow out of the hose.
3.Do the Drain programme and let it operate until the end of the cycle.
4.Turn the programme knob to Stop to disconnect the appliance from the power supply.