26 www.aeg.com
THE INLET HOSE
90˚ |
1.Connect the hose to the appliance. Loose the ring nut to set it in the cor- rect position.
2.Connect the water inlet hose to the cold water tap with 3/4 thread.
CAUTION!
Make sure that there are no leaks from the couplings.
Do not use an extension hose if the inlet hose is too short. Contact the service centre for the replace- ment of the inlet hose.
Water-stop device
A
The inlet hose has a water stop device. This device prevents water leaks in the hose because of its natural ageing. The red sector in the window «A» shows this fault .
If this occur, close the water tap and con- tact the service centre to replace the hose.
WATER DRAINAGE
There are different procedures to connect the drain hose: