AEG 74335 manual Instructions

Operating Instructions

Problem	Possible Cause	Solution
	The transport packaging has	Remove transport packaging
		according to the installation
	not been removed.
		and connection instructions.
	The height-adjustable screw	Adjust the feet according to
		installation and connection
	feet are wrongly positioned.
		instructions.
The washing machine	There is very little washing in	This does not impair the
vibrates during opera-
tion or is unstable.	the drum (e.g. only one	function.
	dressing gown).
	The water could not be com-	Check the drain hose and re-
		move any kinks if necessary,
	pletely pumped out before	or clean the drain pump and,
	spinning because
		if required, remove foreign
	the drain hose is kinked or
		bodies from the pump hous-
	the drain pump is blocked.
		ing.
		It may be necessary to re-
Excessive foaming dur-	Probably too much detergent	duce the amount of deter-
		gent used. Follow the
ing the main wash.	was used.	detergent manufacturer's
		recommendations.
	The screw connection on the	Tighten the inlet hose screw
	inlet hose is leaking.	connection.
	The drainage hose is leaking.	Check the drainage hose and
		replace it if necessary.
	The drain pump cover is not	Close cover correctly.
	correctly closed.
Water runs out from	Washing is caught in the	Stop the programme, remove
under the washing ma-		washing from the door, start
chine.	door.	a new programme.
		Seal the emergency drain
		hose correctly (see section
	The emergency drain hose is	“Carrying out an emergency
	not correctly sealed or is	emptying“). Call your local
	leaking.	AEG Service Force Centre if
		the emergency drain hose
		leaks.

30