AEG 74335 manual Electrical Connection, Measures not be observed, Earth Blue Neutral Brown Live

Installation and connection instructions

Electrical Connection

Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person.

1	WARNING - THIS APPLIANCE MUST BE EARTHED.
	The manufacturer declines any liability should these safety
	measures not be observed.
	Before switching on, make sure
	the electricity supply voltage is
	the same as that indicated on the
	appliance rating plate.
	The rating plate is located at the
	top of the rim of the open door.
	The appliance is supplied with a
	13amp plug fitted. In the event of
	having to change the fuse in the
	plug supplied, a 13amp ASTA ap-
	proved (BS 1362) fuse must be used.
	Should the plug need to be replaced		Green & Yellow
	for any reason, proceed as described
	below.
	The wires in the mains lead are
	coloured in accordance with the
	following code:	Blue		Brown
	Green and Yellow:	Earth
	Blue:	Neutral
	Brown:	Live	Cord Clamp

•The wire coloured green and yellow must be connected to the termi-

nal marked with the letter “E“ or by the earth symbol or coloured green and yellow.

•The wire coloured blue must be connected to the terminal “N“ or coloured black.

•The wire coloured brown must be connected to the terminal marked “L“ or coloured red.

•Upon completion there must be no cut, or stray strands of wire present and the cord clamp must be secure over the outer sheath.

42