AEG 60900, 61900 Electrical connection, Connecting to the water supply, Permitted water pressure

Page 31

Electrical connection

Details about the voltage, type of supply and the fuses required are to be found on the rating plate. The rating plate is next to the doorway.

Connecting to the water supply

Permitted water pressure

The water pressure must be at least 0.5bar (=5N/cm2 =0.05MPa) and may be a maximum of 10bar (=100N/cm2 =1MPa).

If more than 10bar: Connect a pressure reduction valve.

If less than 0.5bar: Disconnect the appliance end of the inlet hose from the solenoid inlet valve and remove the flow meter. (In addition remove the filter using pointed pliers and take out the rubber gasket behind it.) Re-insert the filter.

Water inlet

Attention!

An inlet hose is supplied and can be found inside the machine drum.

Do not use the hose from your previous machine to connect to the water supply.

This appliance must be connected to a cold water supply.

1.Open the porthole and extract the inlet hose.

2.Connect the hose with the angled connection to the machine.

Important!

Do not place the inlet hose down- wards. Angle the hose to the left or right depending on the position of your water tap.

3. Set the hose correctly by loosening the ring nut. After positioning the inlet hose, be sure to tighten the ring nut again to prevent leaks.

31

Image 31
Contents Lavamat 61900/60900 Dear customer Following symbols are used in the textContents Safety information for the installation Installation and connection instructionsFollow the Instructions for installation and connection SafetyPrior to using for the first time Child safety and Infirm PersonsThis could constitute a fire hazard through overheating General safetyControl panel Description of the applianceDrain Spin Programme overviewApplication/features Sorting washing Before the first washPreparing and sorting washing Preparing washingTo open the door gently pull the handle on the door Running a washing cycleOpening the door/Loading the washing Adding detergent/additivesIf you use liquid detergents Washing powder/tablets for the main washChanging the spin speed/Selecting rinse hold Switching on the appliance/selecting a programmeSelect the programme Setting the delay timerSelecting the programme options Shortened wash programme for less soiled itemsProgramme progress Starting a programmeAdding washing Interrupting a programme/Adding washingEnd of the wash cycle/Removing the washing Interrupting a programmeReleasing the child safety device Child safety deviceCleaning and maintenance Cleaning procedureDoor and rubber collar Clean the glass in the door and the rubber collar regularlyDetergent dispenser drawer Washing drumRemedying small malfunctions What to do ifBeen removed After the last rinse foam can still be seen If the wash results are not satisfactoryWashing is grey and scale is being deposited in the drum There are grey stains on the washingCarrying out an emergency drain When the water has all drained awayDrain pump Packaging material DisposalOld appliance Consumption values Technical dataSafety information for the installation Installation and connection instructionsUnpacking Installing the applianceWhen moving using a sack trolley Transporting the appliancePage Remove the bracket D Refit the six smaller bolts C Making the appliance level Where to installWater inlet Connecting to the water supplyElectrical connection Permitted water pressureAqua Control Small basins are not suitable. Wa Ter may overflow Water drainagePumping heights over 1 m Draining water into a wash basin/bathOtros puntos de Postventa en el extranjero Further after-sales service agencies overseasAutres agences étrangères assurant le service après-vente Weitere Kundendienststellen im AuslandAustralia Korea South Namibia Japan Singapore Slovenia Èeská republika +420 2 61 12 61 Budìjovická 3, Praha 4, 140 European GuaranteeMagyarország +36 Service 132 973 Subject to change without notice