AEG 61900, 60900 manual Aqua Control

Page 32

4.Connect the hose to a tap with a 3/4” thread.

Always use the hose supplied with the appliance.

Installation should comply with local water authority and building regula- tions’ requirements.

A minimum water pressure of 0.05 MPa (0.5 bar) is required for safe op-

eration of the appliance.

If you cannot make the cold water

connection direct from the rising mains, you may be able to operate the appliance from your cold water storage system.

There should be a minimum distance of 5.02m (16.5 ft) between the appliance’s inlet and the bottom of the water storage tank.

Aqua Control

The inlet hose is provided with a wa- ter stop device, which protects against damage caused by water leaks in the hose which could devel- op due to natural ageing of the hose. This fault is shown by a red sector in the window „A”. Should this occur, turn the water tap off and re- fer to your Service Centre to replace the hose.

32

Image 32
Contents Lavamat 61900/60900 Following symbols are used in the text Dear customerContents Installation and connection instructions Safety information for the installationSafety Prior to using for the first timeChild safety and Infirm Persons Follow the Instructions for installation and connectionGeneral safety This could constitute a fire hazard through overheatingDescription of the appliance Control panelProgramme overview Drain SpinApplication/features Before the first wash Preparing and sorting washingPreparing washing Sorting washingRunning a washing cycle Opening the door/Loading the washingAdding detergent/additives To open the door gently pull the handle on the doorWashing powder/tablets for the main wash If you use liquid detergentsSwitching on the appliance/selecting a programme Changing the spin speed/Selecting rinse holdSetting the delay timer Selecting the programme optionsShortened wash programme for less soiled items Select the programmeStarting a programme Programme progressInterrupting a programme/Adding washing End of the wash cycle/Removing the washingInterrupting a programme Adding washingChild safety device Cleaning and maintenanceCleaning procedure Releasing the child safety deviceClean the glass in the door and the rubber collar regularly Detergent dispenser drawerWashing drum Door and rubber collarWhat to do if Remedying small malfunctionsBeen removed If the wash results are not satisfactory Washing is grey and scale is being deposited in the drumThere are grey stains on the washing After the last rinse foam can still be seenWhen the water has all drained away Carrying out an emergency drainDrain pump Old appliance DisposalPackaging material Technical data Consumption valuesInstallation and connection instructions Safety information for the installationInstalling the appliance When moving using a sack trolleyTransporting the appliance UnpackingPage Remove the bracket D Refit the six smaller bolts C Where to install Making the appliance levelConnecting to the water supply Electrical connectionPermitted water pressure Water inletAqua Control Water drainage Pumping heights over 1 mDraining water into a wash basin/bath Small basins are not suitable. Wa Ter may overflowFurther after-sales service agencies overseas Autres agences étrangères assurant le service après-venteWeitere Kundendienststellen im Ausland Otros puntos de Postventa en el extranjeroAustralia Korea South Namibia Japan Singapore Slovenia European Guarantee Èeská republika +420 2 61 12 61 Budìjovická 3, Praha 4, 140Magyarország +36 Service 132 973 Subject to change without notice