Use 13
First Use
Ensure that the electrical and water connections comply with the installation instructions.
Remove the polystyrene block and any material from the drum.
Run a cotton cycle at 90 or 95°C , without any laundry in the machine, to remove any manufacturing residue from the drum and tub. Pour 1/2 a measure of detergent into the dispenser drawer and start the machine.
Setting the language
When switching on the appliance for the first time, by turning the programme selector dial 1, you must set the language that you prefer. When the appliance is switched on again all the messagges in the display will appear in this language.
Important!
If the display is not showing any language, the appliance has already been switched on once. In such case, if you would change the language setting, press at the same time the buttons 2 and 3 for 6 seconds to activate the menu language.
By pressing the button 4 you can scroll all the available languages. Press the button 5 twice to confirm your choice.
Setting the time
After the desired language you must set the time before the first wash. Remember to change the setting time in accordance with
The CLOCK setting permits you to modify/set up the current time. It is important to keep it updated as the current END Cycle Time depends on it.
To set the time press reaptedly the button 4 to select the SETTINGS menu and confirm your choice by pressing button 5.
With a single and short pressing of the button 4, the hours can be adjusted.
Press the button 5 to confirm it. Repeat the previous operation for setting the minutes.
Important!
If the appliance has already been switched on once, refer to «Personalization» chapter.