AEG 86850 manual Positioning and levelling, Water inlet

Page 44

44Installation

Positioning and levelling

Install the machine on a flat hard floor.

Make sure that air circulation around the machine is not impeded by carpets, rugs etc.

Before placing it on small tiles, apply a rubber coating.

Never try to correct any unevenness in the floor by putting pieces of wood, cardboard or similar materials under the machine.

HEC007S

If it is impossible to avoid positioning the machine next to a gas cooker or coal- burning stove, an insulating panel covered with aluminium foil on the side facing the cooker or stove, must be inserted between the two appliances.

The machine must not be installed in rooms where the temperature can drop below 0.

The water inlet hose and the drain hose must not be kinked.

Please ensure that when the appliance is installed, it is easily accessible for the engineer in the event of a breakdown.

Carefully level by screwing the adjustable feet in or out. Never place cardboard, wood or similar materials under the machine to compensate for any unevenness in the floor.

Automatic foot: The rear foot on the left-hand side of your washing machine is built as a shock absorbing foot, which is why the appliance gives in the back left-hand corner if put under load. The automatic foot guarantees that the appliance does not move even at high spin speeds. Basically the automatic foot does not need to be set.

Water inlet

An inlet hose is supplied and can be found inside the machine drum.

Do not use the hose from your previous machine to connect to the water supply.

This appliance must be connected to a cold water supply.

1.Open the porthole and extract the inlet hose.

2.Connect the hose with the angled connection to the machine.

Image 44

Contents Lavamat Dear Customer Contents Washing programmes Programme information Washing hints Enviroment concerns General safety Safety informationPrior to using for the first time Installation UseChild Safety Keep all detergents in a safe place out of children’s reachProduct description Detergent dispenser drawerControl panel Display Display shows the following informationDelay start Alarm codesProgramme progress display Incorrect option selectionFirst Use Setting the languageSetting the time Setting the brightness Setting the contrastSetting the acoustic signal PersonalizationDaily Use Return to main menuLoad the laundry Measure out the detergent and the fabric softenerSelect the temperature button Programme options button Select the Prewash optionSelect the Stain option Select the Sensitive optionSelect the Extra Rinse option Select the Save Memory optionSetting Child lock option Selection of the Child Lock optionSelect the START/PAUSE button Select the Delay Start buttonSelect the Time Saving option button Interrupting a programme Cancelling a programmeAltering an option or a running programme Opening the door after the programme has started At the end of the programmeWashing programmes Type of laundryDelicate Programme Programme informations Silk Outdoor Sports Temperatures Preparing the wash cycleSorting out the laundry Before loading the laundryRemoving stains Laundry weightsMaximum loads Detergents and additives Quantity of detergent to be used Degrees of water hardnessCare and cleaning Drain pump Washing drumDoor seal There can be hot water in the pump. Never Emergency emptying out Frost precautionsWater inlet filter What to do if START»Machine does not fill Machine fills then empties immediately Problem No water is visible in the drum Technical Data Consumption value KWhInstallation UnpackingInstallation Positioning and levelling Water inletWater-stop device Water drainageOnto a sink outlet spigot Interest of the environment Electrical connectionPermanent connection Enviroment concerns Packaging materialsOld machine Ecological hintsStandard guarantee conditions 0870 5 929Customer Care 132 966 571-00-052008 Subject to change without notice