AEG 52840 manual Machine fills then empties immediately

Page 33

Something not working 33

Problem

The machine fills then empties immediately:

The machine does not empty and/or does not spin:

There is water on the floor:

Possible cause/Solution

The end of the drain hose is too low.

Refer to relevant paragraph in «water drainage» section.

The drain hose is squashed or kinked. (Yellow

Start/Pause pilot light flashes)

• Check the drain hose connection.

The drain pump is clogged. (Yellow Start/Pause pilot light flashes)

• Clean the drain pump.

The option has been selected.

Disable the option .

Select the option or .

The laundry is not evenly distributed in the drum.

• Redistribute the laundry.

Too much detergent or unsuitable detergent (creates too much foam) has been used.

• Reduce the detergent quantity or use another one.

Check whether there are any leaks from one of the inlet hose fittings. It is not always easy to see this as the water runs down the hose; check to see if it is damp.

• Check the water inlet hose connection.

The drain hose is damaged.

• Change it with a new one.

The cap on the emergency emptying hose has not been replaced after cleaning the pump.

Put the cap back on the emergency emptying and place the latter back in its seat.

Image 33
Contents Lavamat Dear Customer Contents Preparing the wash cycle 21-25 Packaging materials Old machine Ecological hints Installation 38-42Safety information Prior to using for the first timeGeneral safety Installation Child Safety UseKeep all detergents in a safe place out of children’s reach Detergent dispenser drawer Product descriptionControl panel First Use«Stain» button «Extra quick» button «Start/Pause» button Load the laundry Daily UseMeasure out the detergent and the fabric softener If required, pour fabric softener intoSelect the spin speed or the rinse hold option Select the required programmeSelect the Stain option Programme option buttonSelect the «Start/Pause» Select the Extra Quick optionDesired delay. The relevant light illuminates Select the Delay StartDelay Start can not be selected with Drain programme Programme progress displaySelect an additional rinse Cancelling a programmeAltering an option or a running programme Interrupting a programmeAt the end of the programme Options Description Programme Washing programmesOptions Wool Handwash /Silk Delicate rinses Drain Spin Refresh Programme informationsPreparing the wash cycle TemperaturesSorting out the laundry Before loading the laundryLaundry weights Following weights are indicativeMaximum loads Removing stains Detergents and additives Quantity of detergent to be usedMarked before starting the wash programme Degrees of water hardness International wash code symbols Care and cleaning Door seal Washing drumDrain pump Clean the pump if necessary as previously described Water inlet filterEmergency emptying out Frost precautions Something not working Possible cause/SolutionMachine fills then empties immediately Possible cause/Solution Problem Possible cause/Solution Door included Techinical DataDelicate rinses Drain Spin Refresh Eco Consumption valueInstallation UnpackingPolystyrene base from the bottom Installation Positioning and levelling Water inletConnect the hose with the angled connection to the machine End of the drain hose can be positioned in three ways Water drainagePermanent connection Electrical connectionPackaging materials Enviroment concernsOld machine Ecological hintsEuropean Guarantee Customer service centres 192 999 930-01-252008 Subject to change without notice