AEG 52840 manual Positioning and levelling, Water inlet

Page 40

40Installation

Positioning and levelling

Install the machine on a flat hard floor.

Make sure that air circulation around the machine is not impeded by carpets, rugs etc.

Before placing it on small tiles, apply a rubber coating.

Never try to correct any unevenness in the floor by putting pieces of wood, cardboard or similar materials under the machine.

If it is impossible to avoid positioning the machine next to a gas cooker or coal-burning stove, an insulating panel covered with aluminium foil on the side facing the cooker or stove, must be inserted between the two appliances.

The machine must not be installed in rooms where the temperature can drop below 0.

HEC007

The water inlet hose and the drain hose must not be kinked.

Please ensure that when the appliance is installed, it is easily accessible for the engineer in the event of a breakdown.

Carefully level by screwing the adjustable feet in or out. Never place cardboard, wood or similar materials under the machine to compensate for any unevenness in the floor.

Water inlet

An inlet hose is supplied and can be found inside the machine drum.

Do not use the hose from your previous machine to connect to the water supply.

This appliance must be connected to a cold water supply.

1.Open the porthole and extract the inlet hose.

2.Connect the hose with the angled connection to the machine.

Do not place the inlet hose downwards. Angle the hose to the left or right depending on the position of your water tap.

HEC0006

Image 40

Contents Lavamat Dear Customer Contents Preparing the wash cycle 21-25 Installation 38-42 Packaging materials Old machine Ecological hintsPrior to using for the first time Safety informationGeneral safety Installation Use Child SafetyKeep all detergents in a safe place out of children’s reach Product description Detergent dispenser drawerFirst Use Control panel«Stain» button «Extra quick» button «Start/Pause» button Daily Use Load the laundryMeasure out the detergent and the fabric softener If required, pour fabric softener intoSelect the required programme Select the spin speed or the rinse hold optionProgramme option button Select the Stain optionSelect the Extra Quick option Select the «Start/Pause»Select the Delay Start Desired delay. The relevant light illuminatesDelay Start can not be selected with Drain programme Programme progress displayCancelling a programme Select an additional rinseAltering an option or a running programme Interrupting a programmeAt the end of the programme Washing programmes Options Description ProgrammeOptions Programme informations Wool Handwash /Silk Delicate rinses Drain Spin RefreshTemperatures Preparing the wash cycleSorting out the laundry Before loading the laundryFollowing weights are indicative Laundry weightsMaximum loads Removing stains Quantity of detergent to be used Detergents and additivesMarked before starting the wash programme Degrees of water hardness International wash code symbols Care and cleaning Washing drum Door sealDrain pump Water inlet filter Clean the pump if necessary as previously describedEmergency emptying out Frost precautions Possible cause/Solution Something not workingMachine fills then empties immediately Possible cause/Solution Problem Possible cause/Solution Techinical Data Door includedConsumption value Delicate rinses Drain Spin Refresh EcoUnpacking InstallationPolystyrene base from the bottom Installation Water inlet Positioning and levellingConnect the hose with the angled connection to the machine Water drainage End of the drain hose can be positioned in three waysElectrical connection Permanent connectionEnviroment concerns Packaging materialsOld machine Ecological hintsEuropean Guarantee Customer service centres 192 999 930-01-252008 Subject to change without notice