Installing the Noise Damper Plate

Affix the noise proof plate by using the screws provided (TLW16W – 1 Screw / TLW21PS– 2 Screws).

CONNECTING THE WATER SUPPLY HOSES

The water supply hose must be connected to the washing machine at one end and to the water faucet at the other. Do not stretch the water supply hose. If the hose is too short and you do not wish to move the water faucet, replace the hose with a longer, high-pressure hose.

Select appropriate faucet as shown in the figures below. If none of these faucets are available, use the faucet adapter provided.

The end of faucet spout should be longer than 10mm (0.4”), or the connector cannot be fixed properly. Water leakage could develop.

1.Connect the water inlet hose to the faucet by turning the connecting nut.

Rubber ring seal

CONNECTING

NUT

Be sure a rubber ring is inside the connecting nut.

2.Then connect the other end of water inlet hose to the cold connector in water mixing valve by turning the connecting nut.

LID OF

HOT WATER

CONNECTINGCONNECTOR NUT

WATE R

INLET HOSE

COLD WAT ER

CONNECTOR

If you have both cold and hot water supplied, connect the inlet hoses by matching cold to cold and hot to hot.

1.Connect the water inlet hoses to the faucets by turning the connecting nuts.

CONNECTING NUT

WATER INLET HOSE	CONNEC TIN G
	N UT

Be sure the rub ber rings are inside the connecting nuts.

2.Unscrew the lid of hot water connector in water mixing valve, and then connect the other end of water inlet hoses to the connectors in water mixing valve by turning the connecting nuts.

CON NEC TIN G

N UTH OT WATER CONNECTOR

WATER

INLET H OSE

COL D W ATER

CON NEC TOR