10
DRAIN HOSE
PUMP
SUMP HOSE
REPLACE DRIVE BELT
1Remove the front panel as directed under "REMOVE FRONT PANEL".
2Remove belt and inspect pulleys for wear and tightness.
3Install new belt on pulleys, check belt tension and adjust as necessary. Install front panel on clothes washer as directed under "INSTALL FRONT PANEL" and plug power cord into electrical receptacle.
REPLACE PUMP
1Remove the front panel as directed under "REMOVE FRONT PANEL".
2Remove sump and drain hoses from pump (with pliers) using a pan to catch any trapped water.
3Remove wires from pump.
4Remove two bolts from pump and remove pump from clothes washer.
5Install wires on new pump, install pump on clothes washer, reconnect sump and drain hoses on pump and reinstall front panel as directed under "INSTALL FRONT PANEL". Plug power cord into electrical receptacle.
REPLACE DRIVE MOTOR
1Remove the front panel as directed under "REMOVE FRONT PANEL".
2Remove belt adjustment bolt and drive belt from motor.
3Remove clip and washer from pivot shaft. Slide shaft to rear far enough to allow motor to come off shaft.
4Note position of wiring plugs on motor and remove plugs from motor.
5Install wiring plugs on new motor as noted, position motor on shaft, slide shaft into position and secure with washer and clip. Install drive belt adjustment bolt on motor. Install drive belt, adjust belt tension and tighten adjustment bolt. Install front panel on clothes washer as directed under "INSTALL FRONT PANEL" and plug power cord into electrical receptacle.
REPLACE TIMER
1Disconnect the appliance from the power source.
2Remove the six screws that hold the control panel to the top.
3Allow the control panel to slide down, pull the top of the control panel out and lift up.
4Lay the control panel face down on the top while removing the timer.
5To release the setting knob pull out on the black shaft extending through the timer. Pull off indicator dial.
6Remove the timer wire harness connection. Lift up locking tap and pull out on the harness until the connector is free from the timer.
7Note the position of the timer. The replacement will be reinstalled in the same position.
8Remove the 5/16 headed screw that holds the timer to the control panel.
9Lift up on timer locking tap labeled "1" and slide the complete timer to the left and remove. Install the new timer in reverse sequence.
10Install timer mounting screw.
11Reinstall the wire connection. Once the timer connection is fully seated, you will hear a slight click. This indicates that the locking tab is locked.
12Replace the timer indicator dial. There is a flat on the inside of the indicator that will match the flat on the timer plastic shaft. This will align the indicator dial on the timer.
13Install knob on timer and push black shaft extending through timer until flush with rear of timer housing.