Staber Industries HXW2305 Installation, Recheck level of clothes washer and adjust as necessary

Page 5

INSTALLATION 5

CAUTION: Use great care when loading, unloading or working around clothes basket with top lid raised. DO NOT allow any items to fall between inner and outer tubs. If this should occur DO NOT START WASHER. The item must be removed from the tub or damage to the clothes basket or water system may occur. If the item cannot be removed by rotating the clothes basket, we recommend removing the item though the sump hose. Refer to maintenance procedures for details.

Uncrate clothes washer using care not to scratch or damage surface of washer.

IMPORTANT: When lifting or moving clothes washer, always do so from left and/or right side of washer. Lifting or moving from the front or back may damage clothes washer.

Lift clothes washer straight up off bottom of shipping container and remove styrofoam shipping block. Unpack clothes basket and accessories.

NOTE: We recommend that all shipping materials be either retained for later use in moving the clothes washer or recycled through a local solid waste management agency.

The water fill hoses are pre-attached to the water inlet valve on the rear of the washer and should not be removed during installation.

Place clothes washer in position taking care to move clothes washer by moving only from either side.

Level clothes washer side-to-side and front-to-back. DO NOT level washer with front higher than back, damage to internal parts can result.

Place a bubble level on top of clothes washer with lid open. Loosen locknuts on leveling legs and level washer. Keep leveling legs as close to washer frame as possible.There should be an equal amount of weight on all four legs.

After washer is level, secure legs by rotating locknuts up against washer frame. Locate the four foot pads and install one on each leveling leg.

Recheck level of clothes washer and adjust as necessary.

Remove all but the lowest drain hose shipping ties from back of washer. Form a 'gooseneck' in free end of hose, place end in standpipe and secure.

Attach free end of each fill hose to appropriate water supply, top hose to hot water supply and bottom hose to cold water supply. Turn water on and check for leaks.

Plug power supply cord into grounded 120V60Hz electrical receptacle only.

WARNING: Do not use adapter plug, extension cord, or remove grounding prong from power supply cord. Do not modify plug provided with this clothes washer. If it will not fit a properly grounded outlet, have a properly grounded outlet installed by a qualified electrician. Electrical current can cause fire and serious bodily harm.

Grounding type wall receptacle

Page 4 Page 6
Image 5
Page 4 Page 6
Contents Staber Clothes Washer Forward ContentsProduct Identification Important Safety InstructionsONE Year Full Warranty WarrantyFive Year Limited Warranty TWENTY-FIVE Year Limited WarrantyRecheck level of clothes washer and adjust as necessary InstallationTo Wash CLOTHES, Follow These Simple Instructions Step Benefits of Staber WasherPrewash Cycle Normal Wash CycleStep Four Things That Affect the Cleanliness of Your Clothes Liquid Dispensing System OperationControls Install Front Panel Maintenance ProceduresHOW to Raise TOP Assembly Accessing the Motor Control BoardReplace Drive Belt Replace TimerReplace Pump Replace Drive MotorReplace TEMPERATURE, Water Level and Wash Cycle Switches Replace Water Valve Replace Pressure SwitchReplace LID Lock Switch Problem Cause Corrective Action TroubleshootingMotor control circuit has failed Part Number Description Quantity PartsPart Number Description PartsParts Parts Parts Staber Industries, Inc
Top Page Image Contents