11
14Reinstall control panel to housing. Insert bottom of control panel into housing first. Then slide the panel into place and secure with six
philips head screws.
NOTE: Do not over tighten the screws or you will strip the holes and the screws will not hold.
15 Plug machine into the 120 vac power supply.
REPLACE TEMPERATURE, WATER LEVEL AND WASH CYCLE SWITCHES
1Disconnect the appliance from the power source.
2Remove the six screws that hold the control panel to the top.
3Allow the control panel to slide down, pull the top of the control panel out and lift up.
4Lay the control panel face down on the top.
5Pull knob off switch to be replaced. Unscrew attaching nut from switch and remove switch from front control panel. Note on a piece of paper, position and color of electrical wires on switch. Remove wires from switch.
6Install wires on new switch as noted. Install switch on control panel
using nut. Reinstall control panel by reversing procedures above. Install knob on switch and plug in power cord.