Maintenance and Care

When you should switch oﬀ the electricity and turn oﬀ the water faucets

Unplug the washer and turn oﬀ the water faucets when not using it, when cleaning it and during maintenance activities.

After washing is complete, always

•Turn oﬀ the water faucets to relieve pressure on the inlet hoses.

•Wipe the inside of washer door with a soft cloth.

Clean the Exterior

As needed, clean the exterior with a rag dipped in luke- warm water and soap. Never use polish of any kind.

Clean the Interior

In hard water areas or where heavily soiled items are frequently washed, you may periodically need to remove body oils or detergent that has accumulated in the drum. To remove this build-up, run the washer through a complete cycle using HOT water and 2 cups of a non-precipitating water softener.

Periodically, apply a thin coat of paste wax to the inner door (especially the area that is immediately next to the door window) to protect it from laundry aid spills and discoloration.

Clean the Dispenser Drawer

As needed, rinse buildup of detergent or other laundry aids from the dispenser drawer. To remove the dispenser drawer, pull it outwards, as indicat- ed in the picture. Then leave it under warm running water for a few minutes.

Clear the coin trap

This washer contains a self-cleaning pump that does not require any cleaning or maintenance. However, small objects (like coins, hair clips, keys, etc.) may ac- cidentally fall into the pump. To avoid possible damage, they are withheld in an accessible coin trap, located at the bottom, right corner of the washer.

If needed, follow these instructions to remove items that may have accidentally been washed and got caught in the coin trap:

1.With the washer OFF and empty, gently ease down the top of the kick-plate panel (right) with a ﬂat blade screwdriver or plastic putty knife.

2.Remove the panel by lifting slightly and pulling forward.

3.Place a small pan or towel under the pump to catch any water still left in the pump.

4.Turn the large knob counterclockwise and then pull the ﬁlter straight out.

5.When ﬁnished cleaning, reinstall the ﬁlter and ensure that it’s securely tightened. Finally, re-ﬁt the kick-plate panel.

Check the Rubber Inlet Hoses Yearly

Inspect the inlet hoses yearly. If you see any cracks, bulges or other signs of wear replace the hose immedi- ately. Record the hose installation/replacement dates on hoses for future reference.

IMPORTANT!

Always replace the inlet hoses after 5 years of use.