Smeg LBS1600X manual Error Signals

Page 25

GB

11The machine does not spin The unbalanced load sensor has triggered because the washing is not uniformly distributed inside the drum. If the washing is wet at the end of the cycle, distribute it well inside the basket and repeat just the spin cycle.

12 Draining water from the

In the event of a power failure or a fault in the appliance, the water inside

drum

the drum can be drained as described in paragraph 6.3

13The washing has not been correctly spun

14Residues of detergent on the washing

15The washing does not dry

Large items have rolled up and are not uniformly distributed inside the drum. Always wash large items together with small ones.

Many phosphate-free detergents contain substances that are difficult to dissolve in water.

Select the Rinse programme or brush the washing.

Check that:

-the water tap is open

 

 

 

- the washing does not weight too much

 

 

 

- the drying time is suitable.

 

 

 

- sufficient drying time has been selected

 

 

 

If the machine does not dry all the same, call the Service Centre to

 

 

 

remove fabric frays from the fan and drying ducts.

16 Washing

results

are

- Too little detergent or an unsuitable detergent may have been

unsatisfactory

 

used.

- Stubborn stains were not pre-treated - The wrong temperature was selected - The drum was overloaded

ERROR SIGNALS

In the event of faults, the machine will display an error code.

Error code

Problem

Door not closed properly. Close it.

Aquastop. Contact the nearest Service Centre after disconnecting the machine from the electrical power supply and closing the water tap.

No water for washing. See point 2 on the troubleshooting table.

The water does not drain. See point 4 on the troubleshooting table.

For all other error codes, contact the nearest Assistance Centre after disconnecting the power supply and closing the water tap.

25

Image 25
Contents Washer Dryer Contents NEW Washing System Safety Warnings Page = brown N = blue = yellow-green Unpacking Installation InstructionsPositioning and Levelling Drain Connection Water Supply ConnectionElectrical Connection Control Panel Description of ControlsLED Display LEDOptions buttons Quick wash Button Page Detergent Tray Washing InstructionsPreparing the Washing Loading the Washing Opening the DoorAdding Detergent and Additives Dosing Liquid Detergents Dosing Powder DetergentsSCALE-REMOVERS Wool programme Modifying Starting ParametersInterrupting or Changing the Washing Programme Starting the Washing ProgrammeEND of Programme Beeper END of ProgrammeGeneral Information Using the Machine for Drying PurposesAutomatic Drying WASH-DRY Programme Timed DryingDRY-ONLY Programme Interruption or Change of Drying ProgrammeExternal Cleaning Cleaning and MaintenanceCleaning the Drum Cleaning the Door GasketCleaning the Detergent Tray Cleaning the Water Inlet Filter Troubleshooting Error Signals Programs Options Other Symbols Control Panel Symbols