Smeg S800TL manual Water stop anti-flooding system, Connect the water drain hose

Page 17

6GB10055.fm Page 17 Monday, August 2, 2004 12:33 PM

Water stop anti-flooding system

(depending on model)

Screw the hose to the water supply tap. Turn the tap fully on and check the water-tightness of the connection.

The washing machine must not be connected to the mixing tap of a non-pressurized water heater!

The inlet hose and the plastic enclosure contain (depending on model) electrical components: do not cut the hose and do not immerse the enclosure in water.

If the flexible hose is damaged, unplug the washing machine from the mains immediately, turn off the tap and replace the hose.

If the flexible hose is too short, replace it with a 3 m Water Stop hose (available from After-Sales Service or from your dealer). This operation must be carried out exclusively by a qualified technician.

Connect the water drain hose

1.Unhook the drain hose from the left and right hose connections, see arrow A in figure.

Important:

Do NOT loosen the drain hose connection from the right side, see arrow B in figure. Otherwise, there is the risk of leakage and of scalding with hot water.

2.Fix the “U” bend (C) to the free end of the drain hose.

A

C

3.Connect the drain hose to the siphon or hook it over the

edge of a sink with the “U” bend.B Small hand basins are not suitable.

The edge of the sink must be no more than 100 cm from the floor.

If you need to add an extension, use a flexible hose of the same size and secure the unions with screw-on hose clips. Maximum overall drain hose length: 2.50 m.

Maximum drain height (“U” bend): 100 cm.

Minimum drain height: 55 cm.

Important:

Make sure there are no kinks in the drain hose and take precautions against it falling while the washing machine is running.

GB 17

Image 17
Contents Contents Install the washing machine Before Using the Washing MachineRemove the packaging and check Electrical connection Remove the transport bracketFirst Wash Cycle Precautions and General RecommendationsSort the laundry Description of the Washing MachinePreparation of the Washing Starching Stain removalDyeing and bleaching Open the machine lid Loading the laundryDosage Detergents and AdditivesFilling up with detergents and additives Choice of the right detergents and additivesProgramme Selection Cleaning the Foreign Body Trap Detergent dispenser Draining Residual WaterPlug the washing machine back Water inlet hose filterWashing machine does not start, no lamp lights up Water inlet hosesWashing machine does not start, but the pilot lamp is on Washing machine stops during the programmePump operates Water stop fault depending on modelWater Stop fault may have been triggered by Wait for the water to cool so as to avoid any accidents Before contacting After-Sales ServiceSpecify Removal of transport bracket Connect the water inlet hose Adjust the feetConnect the water drain hose Water stop anti-flooding systemValid Only For Great Britain And Ireland Fuse replacementTo fit a new plug, proceed as follows Polarized Plugs e.g pin, 13 amp plug conforming to BS 1363AProgramme Selection Knob Temperature Selection KnobOn/Off Button MaxAppliance in Rinse Hold Rinse Hold buttonRapid button Half Load button