Smeg S800TL manual Valid Only For Great Britain And Ireland, Fuse replacement

Page 18

6GB10055.fm Page 18 Monday, August 2, 2004 12:33 PM

ELECTRICAL CONNECTION

Do not use extension leads or multi sockets. Electrical connections must be made in accordance with local regulations.

1) Warning - this appliance must be earthed

This appliance is normally supplied with a mains lead having a plug fitted in the factory which has been checked for correct earth continuity.

If the fitted plug is not suitable for your socket outlet, or if the machine’s mains lead is not fitted with a plug, you should fit a suitable new, good quality plug by following the instructions in (2) below.

Any unsuitable plug should be cut off and disposed of in order to avoid a possible shock hazard should it be inserted into a socket.

2)CONNECTION TO A REWIRABLE PLUG - to be carried out only by a qualified electrician

The wires in the mains lead are coloured in accordance with the following code:

BLUE - “NEUTRAL” (“N”) BROWN - “LIVE” (“L”)

GREEN AND YELLOW - “EARTH” (“E”)

Valid Only For Great Britain And Ireland

To fit a new plug, proceed as follows:

2.1Polarized Plugs (e.g. 3 pin, 13 amp plug conforming to BS 1363A)

a.The GREEN AND YELLOW wire must be connected to the terminal in the plug which is marked with the

letter “E” or by the Earth symbol

 

or coloured

green and yellow.

 

 

 

 

b.The BLUE wire must be connected to the terminal which is marked with the letter “N” or coloured blue.

c.The BROWN wire must be connected to the terminal which is marked with the letter “L” or coloured brown.

2.2Non-polarized plugs (e.g. 2 pin with side earth contact). The wire which is coloured GREEN AND YELLOW must be connected to the earth contact. The other two wires should be connected to the two pins, irrespective of colour.

Fuse replacement

If the mains lead of this appliance is fitted with a

BS 1363A 13amp fused plug, replace the fuse only with an A.S.T.A. approved type conforming to BS 1362 and proceed as follows:

1.Remove the fuse cover (A) and fuse (B).

2.Fit the replacement 13 A fuse into the fuse cover.

3.Refit both into plug.

GB 18

Page 17 Page 19
Image 18
Page 17 Page 19
Contents Contents Remove the packaging and check Electrical connection Before Using the Washing MachineInstall the washing machine Remove the transport bracketPrecautions and General Recommendations First Wash CycleDescription of the Washing Machine Preparation of the WashingSort the laundry Stain removal Dyeing and bleachingStarching Loading the laundry Open the machine lidFilling up with detergents and additives Detergents and AdditivesDosage Choice of the right detergents and additivesProgramme Selection Cleaning the Foreign Body Trap Draining Residual Water Detergent dispenserWater inlet hose filter Plug the washing machine backWashing machine does not start, but the pilot lamp is on Water inlet hosesWashing machine does not start, no lamp lights up Washing machine stops during the programmeWater stop fault depending on model Water Stop fault may have been triggered byPump operates Before contacting After-Sales Service SpecifyWait for the water to cool so as to avoid any accidents Removal of transport bracket Adjust the feet Connect the water inlet hoseWater stop anti-flooding system Connect the water drain hoseTo fit a new plug, proceed as follows Fuse replacementValid Only For Great Britain And Ireland Polarized Plugs e.g pin, 13 amp plug conforming to BS 1363AOn/Off Button Temperature Selection KnobProgramme Selection Knob MaxRapid button Rinse Hold buttonAppliance in Rinse Hold Half Load button
Top Page Image Contents