Smeg KTL6 Appliance exterior and control panel, Appliance interior, Lid seal, Water inlet hoses

Page 11

Appliance exterior and control panel

Clean with a soft damp cloth.

If necessary, a neutral household cleaner can be applied (do not use aggressive or abrasive products).

Appliance interior

After each washing, leave the lid open for some time to allow the inside of the appliance to dry.

If you never or seldom wash your laundry at 95°C, we recommend to occasionally run a 95°C programme without laundry, adding a small amount of detergent, to keep the interior of the appliance clean.

Lid seal

Check the condition of the lid seal periodically and clean it from time to time with a damp cloth.

Water inlet hose(s)

Check the hose regularly for brittleness and cracks. Replace if necessary.

Filter

Check and clean the filter regularly, at least 3 or 4 times a year (see “Cleaning the Filter/ Draining Residual Water”).

Do not use flammable fluids for cleaning the appliance.

Recovering an object that falls between the drum and the tub

If an object accidentally falls between the drum and the tub, you can recover it thanks to one of the removable drum blades:

1.Unplug the washing machine.

2.Remove the laundry from the drum.

3.Close the drum flaps and turn the drum a half-turn.

4.Using a screw-driver, press on the plastic end while sliding the blade from left to right.

5.It will fall into the drum.

6.Open the drum: you can recover the object through the hole in the drum.

7.Refit the blade from inside the drum:

Position the plastic tip above the hole on the right side of the drum.

8.Then slide the plastic blade from right to left until it clips.

9.Close the drum flaps again, turn the drum through half a turn and check the positioning of the blade at all its anchorage points.

10.Plug the washing machine in again.

3

4

4

7

GB 11

Image 11
Contents Contents Before Using the Washing Machine Precautions and General Recommendations Before the First Wash Cycle Adjustable feetDescription of the Washing Machine Dyeing and bleaching Preparation of the WashingSort the laundry Stain removalLoading the laundry Dosage Detergents and AdditivesChoice of the right detergents and additives Using starch powder Where to put detergents and additivesUsing chlorine bleach Cleaning the FILTER/ Draining Residual Water Water inlet hose Detergent dispenserWater inlet hose filter Water inlet hoses Appliance exterior and control panelAppliance interior Lid sealAnimation appears during such update periods Problem Causes, Solutions, TipsContains residues from Blocked see Care and Maintenance Spin cycle InstallationStart/Pause light flashes Description of red indicationsRed indication lamp DescriptionIndication on Description Wait for the water to cool so as to avoid any accidents Before contacting After-Sales ServiceSpecify Removal of transport bracket Make sure there are no kinks in the hose Adjust the feetConnect the water inlet hose Connect the water drain hose Water stop anti-flooding systemPolarized Plugs e.g pin, 13 amp plug conforming to BS 1363A Earth symbolBrown Live L To fit a new plug, proceed as followsKTL Programme Chart Consumption Data