Smeg KTL6 manual Installation, Removal of transport bracket

Page 16

INSTALLATION

Removal of transport bracket

The washing machine is fitted with a transport bracket to avoid any possible damage during transport.

IMPORTANT: Before using the washing machine, the transport bracket at the back MUST be removed.

1.Unscrew the two screws “A” and the four screws “B” with a flat screwdriver or a No. 8 hex nut box spanner.

2.Remove the transport bracket.

3.Replace the four outer screws “B” on the machine and tighten them.

4.Clip the two seals “C” supplied into the openings “D” of the washing machine.

Note: do not forget to replace and tighten the four outer screws.

AB

D

1

1

1

2

C

4 D

4

GB 16

Image 16

Contents Contents Before Using the Washing Machine Precautions and General Recommendations Description of the Washing Machine Adjustable feetBefore the First Wash Cycle Preparation of the Washing Sort the laundryStain removal Dyeing and bleachingLoading the laundry Choice of the right detergents and additives Detergents and AdditivesDosage Using chlorine bleach Where to put detergents and additivesUsing starch powder Cleaning the FILTER/ Draining Residual Water Water inlet hose filter Detergent dispenserWater inlet hose Appliance exterior and control panel Appliance interiorLid seal Water inlet hosesProblem Causes, Solutions, Tips Contains residues from Blocked see Care and MaintenanceSpin cycle Installation Animation appears during such update periodsDescription of red indications Red indication lampDescription Start/Pause light flashesIndication on Description Specify Before contacting After-Sales ServiceWait for the water to cool so as to avoid any accidents Removal of transport bracket Connect the water inlet hose Adjust the feetMake sure there are no kinks in the hose Water stop anti-flooding system Connect the water drain hoseEarth symbol Brown Live LTo fit a new plug, proceed as follows Polarized Plugs e.g pin, 13 amp plug conforming to BS 1363AKTL Programme Chart Consumption Data