RotorROTORBolt ASSEMBLY, STATOR ASSEMBLY, FRICTION DAMPER ASSEMBLY
Remove the BACK COVER.
Unscrew the bolt to pull out the ROTOR ASSEMBLY.
(ROTOR ASSEMBLY)
(1) |
(STATOR ASSEMBLY) |
Damper |
Hinge |
Disconnect the wiring connector.
Unscrew 6 bolts from the STATOR.
Remove the BODY FRAME. (Only 1400 rpm models)
Note : Hook of connector (1) is on the backside
Pull out the HINGE, pressing its snap. 
Do not use the pulled out HINGE again It may be taken off during operation.
(FRICTION DAMPER ASSEMBLY)
Clean the drain pump filter
1.Open the lower cover cap ( ) by using a coin. Turn the drain plug ( ) to pull out the hose.
2. Unplug the drain plug ( ), allowing the water to flow out. At this time use a vessel to prevent water flowing on to the floor. When water does not flow any more, turn the pump filter ( ) open to the left.
3.Remove any foreign material
from the pump filter ( ). After cleaning, turn the pump filter ( ) clockwise and insert the drain plug ( )to the original place. close the lower cover cap.
100 |
1 |
2
3
3
2
30