John Lewis JLWD 1408 Option buttons, Automatic Dry button, Time dry button, Delay start button

Page 12

4 “Option” buttons

Depending on the programme, different functions can be combined. These must be selected after choosing the desired programme and before depressing the “Start/Pause” button.

When these buttons are pressed, the corresponding pilot lights illuminate. When they are pressed again, the pilot lights go out.

If an incorrect option is selected, the pilot lights flash for about 2 seconds and the message Err is displayed.

Press these buttons to select the following options:

Prewash”: select this option if you wish your laundry to be prewashed at 30°C max. before the main wash (not available for Wool and “30 Minute wash”).

The prewash cycle ends with a short spin at 650 rpm in programmes for cotton and synthetic fabrics, whereas in the programme for delicate fabrics the water is only drained. This option can be selected for heavily soiled laundry.

Quick”: select this option for laundry that is only slightly soiled in order to obtain a good wash result in a short time.

This option is not available with the Wool programmes, the Energy saving programmes “Economy” and “30 Minute wash.

The washing time will be reduced according to the type of fabric and the selected temperature.

The recommended max load for cotton is 3.5 Kg.

Extra rinse”: this option can be selected with all programmes, except Wool and “30 Minute wash”. The machine add 2 rinses for cotton and 1 rinse for synthetics and delicates.

This option is recommended for people who are allergic to detergents, and areas where the water is very soft.

5 “Automatic Dry” button

This button allows you to choose the required degree of drying for cottons and synthetics:

-Extra dry (only for cottons)

-Store dry (cottons and synthetics)

-Iron dry (only for cottons)

The drying time is automatically adjusted by the machine: the laundry will be dried to the selected degree of dryness.

6 “ Time dry” button

If you wish to carry out a timed programme instead of an electronic programme push the button until the drying time you want appears in the display according to the fabrics (cotton or synthetics) you have to dry.

For Cottons and Synthetics you can select a drying time from 10 minutes to 130 minutes.

7 “Delay start” button

This button enables you to delay the starting of the programme for 30 min - 60 min - 90 min, 2 hours and then by 1 hour increments up to a maximum of 23 hours. The delay you have selected is shown on the display for about 3 seconds; afterwards, the duration of the programme reappears.

You must select this option after you have set the programme and before you press the “Start/Pause” button.

The time value shown on the display will decrease by one unit every hour.

You can change the delay time at any moment, before you press the “Start/Pause” button.

If you have already pressed the “Start/Pause” button, and you wish to cancel the delay time, proceed as follows:

Set the machine to PAUSE by pressing the “Start/Pause” button;

Press the “Delay start” button until the symbol “0’ ” is displayed.

Press the “Start/Pause” button again.

Important!

The “Delay start” cannot be used with “Drain” or “Spin” programmes.

Note!

With programme “Soak 30°” the selected delay (up to a maximum of 23 hours) corresponds to the soak time of the laundry in the drum.

The door will be locked throughout the delay time (the door locked light is on).

If you need to open the door, you must first set the washer-dryer to Pause by pressing the “Start/Pause” button. After you have closed the door, press the “Start/Pause” button again.

12

Image 12
Contents Jlwd Spin washer-dryer Installation Child SafetyUse Maintenance and Cleaning ServiceEcological hints Environmental InformationContents Child safety feature Description of the ApplianceDoor locked light Detergent dispenser drawerInstallation Technical SpecificationsWashing DryingUnpacking PositioningRemove the polystyrene base Installation on a Suspended Floor Water inletWater drainage Appliance must be connected to a cold water supplyLevelling Special conditionsInterest of the environment Onto a sink outlet spigot«E» or by the earth symbol or coloured green and yellow Electrical connectionPermanent connection Control panel Detergent dispenser drawer Programme selector dialSpin button Spin speedDelay start button Option buttonsAutomatic Dry button Time dry buttonStart/Pause button Display Programme timeSelection of drying time in minutes ExampleProgramme phase indicator lights Programme information Max. load 1.5 kg Final spin speed 900 r.p.mSwitch the machine on Load the laundryMeasure out the detergent Select the spin speed or the Rinse hold optionHow to change an option or a programme during its cycle Select the Delay startHow to interrupt a programme Select the desired optionsEnd of programme Remove the laundry from the washer dryerLeave the door ajar in order to air the machine Drying Press the Start/Pause button to start the programme1000g = 1 kg SheetBath robe Wash Care Symbols Important NotesWashing programmes Off Reset Programme ConsumptionsEnergy Water Description KWh SoakDrying Programmes Degree Type of fabric Max. load Spin speed Drying timeExtra dry Store dryMaintenance and Cleaning Cleaning the water inlet filter Remove any objects from the pump impeller by rotating itScrew the pump cover fully Close the pump door Emergency emptying out Something Not Working Machine vibrates when SpinningDoor will not open Light has gone out Spinning starts late or0870 01 Always insist on genuine spare parts132 973 03/07