John Lewis JLWD 1408 instruction manual Start/Pause button, Display Programme time, Example

8 “Start/Pause” button

This button has two functions:

•Start: after you have selected the desired programme and options, press this button to start the washer- dryer. The light above the button will stop flashing and remain lit.

If you have selected a delay time, the countdown will begin and will be shown on the display.

•Pause: when you press this button again, the programme in progress is interrupted. The light above the button will start flashing. To restart the programme from the point at which it was interrupted, press the button again.

Important!

You must set the washer-dryer to Pause before you make any change in the programme in progress.

9 Display (Programme time)

The following pieces of information are shown on the display:

•Duration of washing programme in hours and minutes, after you have selected a programme (for example 2.05).

2.05

The duration is calculated automatically on the basis of the maximum recommended load for each type of fabric.

While the programme is running (after you have pressed the Start/Pause button), the displayed time value decreases by one unit every minute.

1.25

•The washer-dryer has stopped with water in the tub, if the “Rinse hold” option has been selected or at the end of the “Soak 30°”: this is indicated by a flashing zero. The door locked light is still on and the door is not openable.

•The washer-dryer has completed the programme: this is indicated by a flashing zero. The door locked light has gone off. It is possible now to open the door.

0

After starting the programme, the remaining time is updated every minute.

•Selection of drying time in minutes .

105

After starting the programme, the remaining time is updated every minute.

Important!

If you select a drying time longer than 55’ minutes, after 3 seconds, the display will show it in hours and minutes (see the example below).

Example:

60	1.
	1.00
Time	Time
dry	dry

13