John Lewis JLBIWM1401 Stain button, Quiet button, Delay start button, Compartment marked Prewash

•“Quick”: select this option for laundry that is only slightly soiled in order to obtain a good wash result in a short time.

This option is not available with the Wool programmes, the Energy saving programmes “Economy” and “30 Minute wash”.

The washing time will be reduced according to the type of fabric and the selected temperature.

•“Extra rinse”: this option can be selected with all programmes, except the Wool programmes and “30 Minute wash”. The machine add 2 rinses for cotton and 1 rinse for synthetics and delicates.

This option is recommended for people who are allergic to detergents, and areas where the water is very soft.

6 “Stain” button

Select this button if you wish to add to the washing of heavy soiled laundry a stain phase: at the temperature of 40°C pour a stain removing detergent into the

compartment marked (Prewash).

This function is available in cotton, synthetic and delicates programmes with a temperature of 40° or higher.

The washing time will be prolonged by few minutes. The “Prewash” and the “Stain” options cannot be selected together.

7 “ Quiet” button

When you choose this option, the machine will not drain the water of the last rinse, this will ensure the minimum of creasing to laundry.

As all spinning phases are cancelled, this washing cycle is very quiet and it can be useful at night or in hours with more economical power rate.

The machine will perform 3 additional rinses on cottons and 1 additional rinse on synthetics programmes.

At the end of the cycle, the light corresponding to the option “Quiet” and the “Rinse hold” pilot phase light are on, the “Start/Pause” button light goes out and the door cannot be opened to indicate that the water must be drained.

A blinking zero will appear on the display.

To empty out water there are 2 possibilities:

-Select “Drain” programme and then depress the “Start/Pause” button:

the water is emptied out without spinning.

-Select the “Spin” programme. Select the spin speed by means of the relevant button and then depress the “Start/Pause” button. The water is emptied out and the laundry is spun at the selected spin speed.

Attention!

Before selecting “Drain” programme or “Spin” programme the selector dial must to be positioned on “Off”.

8 “Delay start” button

This button makes it possible to delay the starting of the programme 30 min - 60 min - 90 min, 2 hours and then by 1 hour up to a maximum of 23 hours.

The delay you have selected is shown on the display for about 3 seconds; afterwards, the duration of the programme reappears.

You must select this option after you have set the programme and before you press the “Start/Pause” button.

The time value shown on the display will decrease by one unit every hour.

You can change the delay time at any moment, before you press the “Start/Pause” button.

If you have already pressed the “Start/Pause” button, and you wish to cancel the delay time, proceed as follows:

•set the machine to PAUSE by pressing the “Start/Pause” button;

•press the “Delay start” button until the symbol “0’ ” is displayed.

•press the “Start/Pause” button again.

Important!

•The “Delay start” cannot be used with “Drain” or “Spin” programmes.

Note!

•With programme “Soak 30°” the selected delay (up to a maximum of 10 hours) corresponds to the soak time of the laundry in the drum.

•The door will be locked throughout the delay time. If you need to open the door, you must first set the washing machine to Pause by pressing the “Start/Pause” button. After you have closed the door, press the “Start/Pause” button again.

16