John Lewis JLBIWM1401 instruction manual Cleaning the water inlet filter, Emergency emptying out

Unscrew and remove the filter.

Clean carefully under a fast running tap.

P0039 P0040

Warning

When the appliance is in use and depending on the programme selected there can be hot water in the pump. Never remove the pump cover during a wash cycle, always wait until the appliance has finished the cycle, and is empty. When replacing the cover, ensure it is securely retightened so as to stop leaks and young children being able to remove it.

Cleaning the water inlet filter

If your water is very hard or contains traces of lime deposit, the water inlet filter may become clogged.

It is therefore a good idea to clean it from time to time. Turn off the water tap.

Unscrew the water inlet hose.

Clean the filter using a hard bristle brush. Tighten up the inlet hose.

P1090

The dangers of freezing

If the machine is exposed to temperatures below 0°C, certain precautions should be taken.

●Turn off the water tap.

●Unscrew the inlet hose.

●Unhook the drain hose from the rear support and position the end of this hose and that of the inlet hoses in a bowl. Run the draining programme.

To do this:

●Switch the machine on

●Select the “Drain” programme

●Press “Start/Pause” button

●Disconnect the appliance .

●Screw the inlet hose and reposition the drain hose.

●When you intend to start the machine up again, make sure that the room temperature is above 0°C.

Emergency emptying out

If the water is not discharged, proceed as follows to empty out the machine:

•pull out the plug from the power socket;

•close the water tap;

•if necessary, wait until the water has cooled down;

•open the filter;

•place a bowl on the floor under the filter.

•slightly loosen the filter to let the water come out slowly;

•clean the filter if necessary as previously described;

•screw the filter again and close the door.

28