IPSO 170, 120 installation manual Contents

Page 2

Table of

Contents

Tumblers – 120 and 170	2
Introduction	2
Model Identification	2
Specifications and Dimensions	4
120 Pound Tumbler Dimensions and
Exhaust Outlet Locations	5
170 Pound Tumbler Dimensions and
Exhaust Outlet Locations	6
Electric and Gas Connection Locations for
Gas Models	7
Electric and Steam Connection Locations for
Steam Models	8
Installation	9
Pre-Installation Inspection	9
Tumbler Enclosure	10
Exhaust Requirements	11
Layout	11
Make-Up Air	11
Venting	11
Individual Venting	12
Manifold Venting	14
Electrical Requirements	17

© Published by permission of the copyright owner.

All rights reserved. No part of the contents of this book may be reproduced or transmitted in any form or by any means without the expressed written consent of the publisher.

1

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

4-08-45

Image 2

Contents On-Premise Laundry Planning Handbook Contents Gas Steam/Thermal Oil Pound IntroductionModel Identification Tumblers 120 Conversion Table Multiply To ObtainGas Models Specifications and DimensionsSpecifications Pound Steam ModelsExhaust Outlet Dimensions and Locations Models 120L/N Pound Tumbler Dimensions Exhaust Outlet LocationsCabinet Dimensions Models 120L/N 120S170L/N/S Cabinet Dimensions ModelsExhaust Outlet Dimensions and Locations Models 170L/N/S Non-CE Electric and Gas Connection Locations for Gas ModelsModels Electrical Connection Gas Connection Models Electrical Connection Non-CE Electric and Steam Connection Locations for Steam Models170S Installation Pre-Installation InspectionTumbler Enclosure Make-Up Air Exhaust RequirementsLayout VentingIndividual Venting Duct Equivalent Length Diameter Rigid Straight DuctTMB2103N Manifold Venting Duct Pound Mm DuctDuct Pound Station Mm Duct TWO Manifold AssembliesElectrical Requirements