How to Install the Washing Machine
Conecting the water supply
●Water supply hose
■Optimum water pressure is
■Do not connect to the mixer tap of an unpressurised
■Use a horizontal tap.
Horizontal tap | Extension tap | Square tap |
Connect the water supply hose to the rear panel of the washing machine.
Make sure that the rubber seal is inside the hose connector.
Hose connector
Rubber seal
* Model with SCREW TYPE water supply hose.
Firmly connect the water supply hose to the tap, and check connection points for
* Model with ONE TOUCH JOINT water supply hose.
1.Untighten the upper connector screw.
Upper connector Rubber packing
Fixing screw | Middle |
| connector |
●In case the diameter of the tap is large, remove the guide plate.
Guide plate
Connector
2.Push the upper connector up till the rubber packing is in tight contact with the tap. Then tighten the 4 screws.
Rubber packing Upper connector
Middle connector
●Turn the middle connector so that there is no water leak.
3. Connect the water supply hose to the middle connector, pushing the plate down.
Middle connector |
Water supply hose
24
●To separate the water supply hose from the middle connector, turn off the tap, and then pull the inlet hose down, pushing the plate down.
3WPL083851