HOW TO USE THE WASHER
Cycle Selector Knob
1.Power 
•Use this button to turn the Power On/Off.
2.Cycles
•Rotate the Cycle selector knob to select cycle designed for different types of fabric and soil levels.
•Each cycle has a preset Water Temperature, Spin Speed, Soil Level, and Option (See page 13).
•The preset settings can be changed anytime before Start.
NOTE: This front load washer requires longer cycle time and gets clothes much cleaner, yet is more gentle on the fabrics, than top load washers. Washing time can be reduced significantly for small loads or lightly soiled loads by selecting Speed Wash cycle and setting the Soil Level button at Light.
3.Start/Pause 
•Use this button to start/stop the washer.
NOTE: If you do not press the Start/Pause button within 4 minutes of selecting a cycle, the washer automatically turns off.
1 4
4.Delay Wash
•Allows the start of any cycle to be delayed for 1~12 hours.
•Choose the wash cycle for your load, and then press the Delay Wash button once for one hour or press the button again to increase the delay wash time up to 12 hours in one hour increments.
5.Water Plus
•Adds extra water to the wash and rinse cycles for superior results.
6.SPINSENSETM
•SPINSENSETM can be used when there is a vibration problem, especially on wood floor installations.
•To operate SPINSENSETM press and hold the Water Plus button for 3 seconds when the washing machine is running on any cycle.
•When SPINSENSETM has been selected, the Spin Speed button light will blink on and off continually to indicate that the SPINSENSETM function has been selected.
•Push and hold the Water Plus button again for 3 seconds to cancel SPINSENSETM.
•Once SPINSENSETM has been selected, if will continue to function even if interrupted by a power failure.
•'SPINSENSE' option cannot be selected during the spinning cycle.
7.Extra Rinse
•This option provides an additional rinse.
•Use this option to ensure the removal of detergent or bleach residue from garments.