TROUBLESHOOTING GUIDE
Problem | Possible Cause | Solution |
| • Water supply is not adequate in | Check another tap in the house. |
| area. |
|
| • Water supply taps are not | Fully open tap. |
| completely open. |
|
| • Water inlet hose is bent. | Straighten hose. |
| • The filter of the inlet hose clogged. | Check the filter of the inlet hose. |
| • Drain hose is bent | Clean and straighten the drain hose. |
| or clogged. |
|
| • The drain filter is clogged. | Clean the drain filter. |
| • Load is too small. | Add 1 or 2 similar items to help |
| • Load is out of balance. | balance the load. |
| • The appliance has an imbalance | Rearrange load to allow proper |
| detection and correction system. If | spinning. |
| individual heavy articles are loaded |
|
| (bath mat, bath robe, etc.) and the |
|
| imbalance is too great, after several |
|
| attempts to restart the spin cycle the |
|
| machine will stop and the error code |
|
| will be displayed. |
|
| • Is the door opened or not | Close the door completely. |
| completely closed? | If it is not released, call for service. |
| Unplug the power plug and call for service. | |
|
| |
• The water overfills due to the | Close the water tap. | |
faulty water valve. | Unplug the power plug. | |
| Call for service. | |
• The water level sensor | ||
| ||
malfunction. |
| |
|
| |
• Overload in motor. | Restart the cycle after 30 minutes. If LE is | |
not released, call for service. | ||
| ||
|
| |
• The washer experienced a power | Restart the cycle. | |
| ||
failure. |
|
2 2