Installation
❿Step3: Connect hose to washer
• Make sure that there are no kinks in the hose and that they are not crushed.
❿When your washer has two valves.
• The Inlet hose which has red connector is for the hot water tap.
• If the washer has two valves, the energy is saved by using hot valve.
NOTE
•After completing connection, if water leaks from the hose, repeat the same steps.
Use the most conventional type of faucet for water supply. In case the faucet is square or too big, remove the spacing ring before inserting the faucet into the adaptor.
Please use the horizontal tap
Horizontal tap
Extension tap
Square tap
13