LAUNDRY TUB DRAIN SYSTEM
Check location where washer will be installed. This washer can be installed using one of three; systems:
•Laundry tub drain system (below)
•Standpipe drain system (p. 12)
•Floor drain system (p. 12)
Do not store or operate washer at or below 32°F (some water may remain in washer). See page 31 for Winterizing Information.
Proper installation is your responsibility. Make sure you have everything necessary for correct installation including the following points:
Grounded receptacle: Must be within 4 feet of where the
power cord is attached to the back of the washer.
Hot and cold water faucets:
Must provide water pressure between
Laundry tub drain system:
Needs a minimum
Support: Floor must be sturdy enough to support a total weight of 315 pounds (including washer, water, and load weight),
Level floor: Maximum
allowable slope under entire washer- 1 inch.
Top of tub must be at least 39 inches above
floor and no higher than 96 inches from bottom of washer.
11