C. ,CONNECT DRAIN HOSE
Proper connection of the drain hose will protect your floors from damage due to water leakage.
STEP 1. To prevent the drain hose from coming off or leaking, it must be installed per the following instructions:
IMPORTANT: To ensure proper installa- tion, this procedure must be followed exactly.
a. Wet the inside of the straight end of
the drain hose with tap water. DO NOT USE ANY OTHER LUBRICANT.
b. Squeeze ears of silver,
TWIST
AND
PUSH
d. Place clamp over area marked "CLAMP." Release clamp.
1/4"
/
c. Open clamp. Twist hose back and
forth while pushing down onto drain connector at the bottom of the washer.
Continue until hose contacts the ribbed stop on the cabinet.
If you | have: |
|
| You will need | to buy: | ! | |
[:)rain | hose | that | is too | short | Drain hose, Part No. 388423 | and | |
|
|
|
|
| hose kit, Part No. 285442 |
| |
[)rain | hose | that | is too | long | Hose kit, Part No. 285442 |
| |
A problem | with | lint clogging your drain | Drain protector, | Part No. 367031 | |||
Parts listed are available from your local Sears store or Sears Service Center. |
| ||||||
Call |
|
|
|
14