For standpipe or laundry tub drain
systems:
STEP 2. Open yellow,
corrugated sections together.
HookedEnd
Drain Hose
STEP 3. Put hooked end of drain hose into laundry tub or standpipe. Check
for proper length .of drain hose. Rotate hook to eliminate kinks.
To prevent drain water from going back into the washer:
•Do not straighten hooked end of drain hose, and force excess drain hose into standpipe.
•Do not lay excess drain hose in bottom of laundry tub.
D. CONNECT INLET HOSES
TO WASHER
Proper connection of your inlet hoses will allow hot and cold water to enter
your washer properly. It also helps prevent water damage due to leaks.
Slip and Fall Hazard
Use new water inlet hoses.
Failure to do so can result in head
injury or broken bones.
NOTE: Replace inlet hoses after five years of use to reduce the risk of hose failure. Periodically inspect and replace inlet hoses if bulges, kinks, cuts, wear, or leaks are found. When replacing your inlet hoses, mark the date of replacement on the label with a permanent marker.
STEP 1. Insert one new, flat washer
(from the parts bag) into each end of the inlet hoses. Check that washers
are firmly seated in couplings.
0
COUPLINGWASHER
15