Kenmore 3950144 owner manual Laundry TUB Drain System

LAUNDRY TUB DRAIN SYSTEM

Check location where washer will be installed. This washer can be installed

using one of three systems:

•Laundry tub drain system (below)

•Standpipe drain system (p. 12)

•Floor drain system (p. 12)

Do not store or operate washer at or below 32°F (some water may remain in washer). See page 31 for Winterizing Information.

Proper installation is your responsibility. Make sure you have everything necessary

for correct installation including the following points:

Grounded receptacle: Must be within 4 feet of where the

power cord is attached to the back of the washer.

Hot and cold water faucets: Must provide water pressure between 5-100 psi and be within 4 feet of the hot and cold water fill valves attached to the back of the washer.

Laundry tub drain system: Needs a minimum 20-gallon laundry tub.

Support: Floor must be sturdy enough to support a total weight of 315 pounds (including washer, water, and load weight).

Level floor: Maximum

allowable slope under entire washer- I inch.

Top of tub must be at least 39 inches above

floor and no higher than 96 inches from bottom of washer.

I1