Kenmore 3950144 owner manual Connect Drain Hose

C. CONNECT DRAIN HOSE

Proper connection of the drain hose will protect your floors from damage due to water leakage.

STEP 1. To prevent the drain hose from coming off or leaking, it must be installed per the following instructions:

IMPORTANT: To ensure proper installa- tion, this procedure must be followed exactly.

a. Wet the inside of the straight end of

the drain hose with tap water. DO NOT USE ANY OTHER LUBRICANT.

b. Squeeze ears of silver, double-wire clamp with pliers to open. Place clamp over the straight end of the drain hose 1/4 inch from the end.

d. Place clamp over area marked "CLAMR" Release clamp.

1/4'_ DrainHnsex

c. Open clamp. Twist hose back and forth while pushing down onto drain connector at the bottom of the washer. Continue until hose contacts the ribbed stop on the cabinet.

If you

have:

You

will

need

to

buy:

Drain

hose

that

is

too

short

Drain

hose,

Part

No.

388423 and

hose kit,

Part

No. 285442

Drain

hose

that

is

too

long

Hose

kit,

Part

No.

285442

A problem

with

lint

clogging your drain

Drain

protector,

Part

No. 367031

Parts listed are available from your local Sears store or Sears Service Center. Call 1-800-366-PART (1-800-366-7278).

I4