Whirlpool W10200890B, W10200891B - SP Level Washer, Secure drain hose Engage rear leveling feet

14. Secure drain hose

17. Engage rear leveling feet

Laundry Tub

4.5"

(113 mm)

A

Standpipe	Wall
4.5"
(113 mm)
	4.5"
	(113 mm)
A
	A

Secure drain hose to laundry tub leg, drain standpipe, or inlet hoses for wall standpipe with beaded tie strap (A). This will help reduce the chance of drain water splashing on the floor.

Tilt washer forward; self-adjusting rear feet will click into place. Gently lower washer to floor.

Level Washer

IMPORTANT: Leveling your washer properly reduces excess noise and vibration.

15. Prepare to install leveling feet

1"

(25 mm)

Prop up front of washer about 4" (102 mm) with a wood block or similar object that will support weight of washer. Then screw jam nut onto each foot to within 1" (25 mm) of foot base.

16. Install front leveling feet

18. Check levelness of washer

Place level here

Place a level on top edges of washer, checking each side and front. Rock washer back and forth to make sure all four feet make solid contact with floor. If not level, tip washer and adjust feet up or down, repeating as necessary.

Not Level LEVEL Not Level

Screw feet into threaded holes at front

corners of washer until jam nuts touch washer, but are not tight. Tilt washer back, remove wood block. Gently lower washer to floor and slide washer to its final location. Remove cardboard used to protect floor.

7