BeforeYouStart, RemoveShippingMaterials

■Do not earth to a gas pipe.

■Check with a qualiﬁed electrician if you are not sure the washer is properly earthed.

■Do not have a fuse in the neutral or earth circuit.

3.Locate the yellow shipping materials on the rear of the machine, near the bottom. Follow the steps for your particular model, either the one with the straight power cord and cord restraint or the looped power cord version.

Straight power cord

EARTHING INSTRUCTIONS

For an earthed, cord-connected washer:

This washer must be earthed. In the event of a malfunction or breakdown, earthing will reduce the risk of electrical shock by providing a path of least resistance for electric current. This washer is equipped with a cord having an equipment-earthing conductor and an earthing plug. The plug must be plugged into an appropriate outlet that is properly installed and earthed in accordance with all local codes and ordinances.

WARNING: Improper connection of the equipment- earthing conductor can result in a risk of electric shock. Check with a qualified electrician or serviceman if you are in doubt as to whether the appliance is properly earthed.

Do not modify the plug provided with the appliance - if it will not fit the outlet, have a proper outlet installed by a qualified electrician.

For a permanently connected washer:

This washer must be connected to an earthed metal, permanent wiring system, or an equipment earthing conductor must be run with the circuit conductors and connected to the equipment-earthing terminal or lead on the appliance.

INSTALLATION INSTRUCTIONS

BeforeYouStart

WARNING

Excessive Weight Hazard

Use two or more people to move and install washer. Failure to do so can result in back or other injury.

NOTE: To avoid ﬂoor damage, set the washer onto cardboard before moving across ﬂoor.

RemoveShippingMaterials

Removing the shipping material is necessary for proper operation. If the shipping material is not removed, the washer will make excessive noise.

1.Move the washer to within approximately 90 cm (3 ft) of its ﬁnal location.

2.The washer must be in the upright position and not tilted before removing the shipping material.

Straight power cord

1.Remove power plug and yellow strap from machine base to release the rear leveling system.

2.Firmly grasp the power cord and pull to completely remove the power cord, cord restraint, and pin from the rear panel.

3.Conﬁrm that the power cord restraint (A), and pin (B) are removed.

A. Power cord restraint

B. Pin