Connecting the water supply hose

Installing the Washing Machine

The water supply hose must be connected to the washing machine at one end and to the water faucet at the other. Do not stretch the water supply hose. If the hose is too short replace the hose with a longer, high pressure hose.

To connect the water supply hose:

1.Take the L-shaped arm fitting for the cold water supply hose and connect to the cold water supply intake on the back of the machine. Tighten by hand.

2.Connect the other end of the cold water supply hose to your sink's cold water faucet and tighten it by hand. If necessary, you can reposition the water supply hose at the washing machine end by loosening the fitting,rotating the hose, and retightening the fitting.

NOTICE The appliance is to be connected to the water mains using new hose-sets and that old hose- sets should not be used.

Hot water supply value

Option:

1.Take the red L-shaped arm fitting for the hot water supply hose and connect to the red hot water supply intake on the back of the machine. Tighten by hand.

2.Connect the other end of the hot water supply hose to your sink's hot water faucet and tighten it by hand.

3.Use a Y-piece if you only want to use cold water.

Installing the Washing Machine

Connecting the water supply hose(Option)

1. Remove the adaptor from the water		4. Connect the water supply hose to
supply hose.		the adaptor. Pull down part (c) of the
	c	water supply hose. When you
	c	release part (c) the hose automa-
		tically connects to the adaptor
		making a ’click’ sound.
2. First, using a “+” type screw driver,		5. Connect the other end of the water
loosen the four screws on the		supply hose to the inlet water valve
adaptor. Next, take the adaptor		at the rear of the washer. Screw the
and turn part(b) following the		hose clockwise all the way in.
arrow until there is a 5mm gap.
3. Connect adaptor to the water tap by
tightening the screws firmly.	a
Then, turn part (b) following the	a
arrow and put(a) and (b) together.	b

NOTICE After completing connection, if water leaks from the hose, then repeat the same steps. Use the most conventional type of faucet for water supply. In case the faucet is square or too big, remove the spacing ring before inserting the faucet into the adaptor.

Positioning the drain hose

The end of the drain hose may be positioned in three ways:

Over the edge of a wash basin.

The drain hose must be placed at a height of between 60 and 90 cm. To keep the drain hose spout bent, use the supplied plastic hose guide. Secure the guide to the wall with a hook or to the faucet with a piece of string to prevent the drain hose from moving.

ln a sink drain pipe branch

The drain pipe branch must be above the sink siphon so that the end of the hose is at least 60 cm above the ground.

ln a drain pipe

Samsung recommends that you use a 65 cm high vertical pipe; it must be no shorter than 60 cm and no longer than 90 cm.

4 SAMSUNG Washing Machine Owner’s Instructions

SAMSUNG Washing Machine Owner’s Instructions 5