Lubrication
Proper lubrication and corrosion protection are necessary to maintain optimum performance and ensure years of service from your watercraft. We recommend the use of Polaris All Season Premium Grease. See page 101 for part numbers of Polaris products.
Throttle Cable
1.Lubricate the throttle cable by depressing the throttle lever and squirting grease onto the cable.
2.Push and release the throttle several times to work the grease down the cable.
Steering Cable Joints and Inner Wire
1.Lubricate the steering cable joints on the steering nozzle end.
2.Expose the steering cable inner cable and apply grease. Lubricate the steering nozzle end and the handlebar end.
NOTE: Cable seals can be moved to allow grease into the cable. Make sure the seals are put back in the proper location after applying grease.
MAINTENANCE AND LUBRICATION
Drive Line
The drive line consists of a drive shaft spider coupler and a bearing carrier with a sealed bearing inside. It does not require routine greasing. However, grease is required during reassembly of the system when it’s been disassembled for service. Grease must be applied to the drive shaft before it’s installed through the bearing carrier. NOTE: We recommend that all drive line service be performed by your Polaris dealer.
CAUTION
Failure to apply grease to the driveshaft during reassembly through the bearing carrier will result in dislodged seals and improper operation of the system. Always apply grease when reassembling.
Inspect the rubber spider coupler (1) monthly. See your Polaris dealer for replacement if wear or damage is found.
Inspect the bearing carrier (2) for water leaks through or around the drive shaft. See your Polaris dealer for replacement if a leak is detected.
79
